Sharing correct operation and method of switching switch
Release time：2019-05-27 Clicks： Click
The correct operation of the switch is very important. At the same time, there are some ways to share with you. Please know more about it.
The operation of the toggle switch has a direct impact on the performance of the switch, so how to operate the toggle switch?
1. Machining the driving rod will exert excessive external force on the internal mechanism of the switch, resulting in the change of its characteristics and the failure of the switch.
2. Use smoothly shaped switching operators (cams, blocks, etc.). The quick recovery of the driving rod of the switch may lead to the damage of the driving rod and shorten the service life of the driving rod when it is impacted.
3. Please operate according to the direction of the driving rod. In the needle button type, press the button vertically.
4. The angle of cam and block of ball pendulum bar should be set in the range of 30-45 degrees. If the angle is too large, it will cause abnormal transverse stress on the swing bar.
5. Do not apply partial load on the driving rod during operation. Otherwise, the local friction may lead to the damage of the driving rod and shorten the service life.
6. When using the external swing rod as an operator, in order to determine the additional load according to the operating load of the switch, please confirm the material, plate thickness and so on.
7. Ball pendulum and R-shaped pendulum should be operated in the direction shown below.
The operation method of the switch is shared with you here. If you want to operate the switch, you can refer to the above method for operation. If you have any ambiguity, you can contact our online customer service.